- Brand: Partsam
- Color: Red
- Specific Uses For Product: Boat Lights, Rear Lights, Stop Lihgts, Brake Lights, Turn Signal Lights, Running Lights
- Light Source Type: LED
- Vehicle Service Type: Universal for Under 80″ Inch width towing vehicle, like truck, trailer, tractor,semi-trailer,Dump Truck,boat, bus, Lorry, Van, caravan, snowmobile, Camper, RV.etc See more
- Special Feature: Submersible
- Voltage: 12 Volts
- Position: Rear
- Lens Color: Red Lens
- Lens Material: Acrylic
- Application: Universal for Trucks, trailers under 80″, tractors, semi-trailer, Dump Truck, bus, boat, special vehicle,etc
- 15 Diodes ( 12 Red+3 Red ) LED Combination stop turn tail side marker light w/reflector-Curb side; Passenger Side Serves 6 functions: Stop light, Turn signal light, Tail light, Rear reflex reflector, Side marker light, Side reflex reflector;
- 19 Diodes ( 12 Red+3 Red+4 White ) LED Combination stop turn tail side marker light w/reflector-Street side with license illuminator; Driver Side Serves 7 functions: Stop light, Turn signal light, Tail light, Rear reflex reflector, Side marker light, Side reflex reflector, License plate illuminator;
- Add or upgrade the lights on boat, snowmobile, camper, or utility trailer; High visibility safety lights are EASY TO INSTALL and the wiring details are in the description part; completely sealed and waterproof, its acrylic len are engineered to block water out and ensure the circuits are protected. Super bright LED lights provide maximum visibility and safety. Fully operable in inclement weather, these heavy duty trailer lights are tough and durable for the long term
- Package include: 1 Pairs Lights + 2 Gaskets + 4 Screws;














![Outlet ✔️ 4pc 4" Round Red LED Trailer Tail Lights [DOT Certified] [Grommet & Plug Included] [IP67 Waterproof] Turn Stop Brake Trailer Lights For RV Trucks ????](https://www.headlight-store.com/wp-content/uploads/2022/12/51Etlov9VKL-247x247.webp)







North Shore –
I installed these on a utility trailer with the same lights everyone has. The bulb connectors corroded and I couldn’t make them work. The pair of Partsam replacements was less than half the cost of the OEM type. They are completely sealed, including silicone around the wires that exit the back. My only complaint is the wires come out of the center of the back instead of from the bottom edge, so they are compressed against the mounting plate if it doesn’t have a hole in the center. A couple washers between the light and trailer light bracket fixed that. SUPER BRIGHT.
harley611 –
These were easy to install. Of course it had the normal two wires to hook up, but they also had a ground wire that needed to be dealt with. I placed a connecter on the end and then attached it to the stud on the light itself since it bolts to the trailer. They work great and are way brighter than the ones that came on the trailer new. I would recommend this product.I can’t say anything about it being waterproof because I only installed them a couple days ago.
Jay –
I used these lights for my trailer. They were easy to hook up and are far brighter than my previous halogen lights. It doesn’t hurt that they are priced the same amount as you would find in store for one. I would buy again.
Wayne c –
This trailer lights are fantastic they bolt on easily wire up easily and when they’re lit up nobody cannot see you from behind nice and bright and clear I recommend them I put them on my little trailer for my wheelchair and I know I won’t have to replace them again for years to come the LEDs are a nice addition to it because it’s bright he uses less wattage to light them and you can always fix the LEDs just by finding the one that is blown out and putting a little piece of wire around the bottom of the LED so you can reconnect the circuit but I don’t see you having to do that for a long time they will be great on boat trailers in all trailers I highly recommend them
Andy –
I like this light set. It fits my trailer, has a ground wire instead of relying on the bolt on the back of the back if the light to ground them.. After breaking both of my previous lights in a single night I bought some steel protective covers as well. Hopefully it won’t happen again. The only thing that I dislike is that the circuit board is completely waterproof and encapsulated in a resin of some kind, the opening where the wires enter the lights allows water to enter into the housing. It doesn’t effect the electronics but it does leave moisture on the lenses. A minor issue for quality lights that are a great value
Hport –
These replaced the factory incandescent units on our Carry All utility trailer. Good brightness and no complaints on construction and fit. There are two lights in the box, drivers side has license plate light below. The two mounting studs are located on the backside, these are not side mount lights.
Randy Coleman –
Absolutely ???? nice sleek design. Looks great at night when you hit the brake pedal !!!
Richard Beale –
I used these lights to replace 20 year old utility trailer lights. Fit perfectly and easy swap. Hope they last as long.