- Brand: Frienda
- Light Source Type: LED
- Special Feature: Waterproof
- Voltage: 12 Volts
- Position: Front
- Lens Material: Plastic
- Size information: the windshield lights bar measures approx. 4.45 inches/ 11.3 cm in length, and the electric wire measures approx. 25.6 inches/ 65 cm in length, long enough for you to install and make you have a safe driving experience
- Two modes: the LED surface mount lamp is designed with 2 modes of use-constant light mode and strobe mode, you need to connect the red cable to the positive terminal, connect the black cable to the negative terminal, and the yellow cable is connected to the positive pole to change the blinking pattern, if the yellow line hits the red line, the mode will be changed, and when the yellow line is released, the mode will be fixed
- Ample quantity: you will be provided with 6 pieces emergency strobe lights with 6 pieces black pads and 2 sets screws, ample quantity and thoughtful accessories will meet your daily use requirements
- Where to apply: the car light strobe bars are suitable for many vehicles with 12 volt to 24 volt voltage, such as trucks, SUVs, ATV, construction vehicles, cars and so on, give your car a good lighting effect while driving
- Waterproof and anti-collision: the hazard shiny strobe light is made of plastic material with a waterproof shell, waterproof and can resistant to bad weather, strong fog penetration, dust-proof, good corrosion resistance; And the matching black pad can prevent impact and avoid wear































Ryan –
I bought this 12 pack of lights. After installing 1 of 12 did not work (I thought checked them all first but I guess not). I contacted the seller and asked they replace the inoperable light. The seller stated they could not send me one light because they come in packs and could not open the packs, but they would give me a $3 refund (which is about the price of 1 light). I told them that was not acceptable and requested they either refund me the price of the 4 pack of lights (the smallest pack option they offer) or send me a 4 pack since they “can’t open a pack”. They agreed to send me the 4 pack as replacement. Overall happy with the lights. But be prepared that they may not all work.
Bhill671 –
The media could not be loaded. These are nice and bright, no doubt about that. I forget sometimes that Light Emitting Diodes can be super sensitive to input voltage; I worked diligently most of the weekend to integrate them into these magnetic base HF T00ls universal tail/stop lights I’ve been using on our tractor for about 10 years (LOL). I soldered all the connections (which I highly recommend with this tiny conductor wire) and added some momentary buttons to the yellow lead for changing the flash-pattern. All finished — NOPE! was as anticlimactic as Clark W Griswold— NOTHING! And the incandescent tails tied to the SAME CIRCUIT and conductors worked fine!?!? WTH? At first I suspected they were tripped up by proximity to the strong magnets on the bases. . . NOPE – still didn’t work. Finally I thought that competing with the headlights and tail lights without the engine running (plus the unnecessarily long wiring on the HF fixtures) was too much— Sure enough, hooked them to a different ignition circuit and VIOLA! (Clark Griswold again)
Hunter Moeller –
Pretty good lights super easy to put on!Just not 100% water proof l. You can see the plastic pulling apart under a bend and it’s exposing the electronics
Betty Chambers –
The lights had condensation in them after the first rain won’t last after mold gets in them
Allison Jamison –
Install was easy, wired straight to stock up fitter switches. Needs a 15 amp power source at least they just aren’t very bright.
cowboy12 –
I bought a pack of four for on my RZR as emergency lights. Word of advice get each light on the same flashing squence then link them together and use a momentary switch to change flash patterns. Works well.
Carlos –
Depends what you want them for. They are ok but compared to very similar ones, these one are very sensitive to lead drop and are not as bright as described
LREII –
The media could not be loaded. These are easy to install and are programmable by touching the yellow wire to the red wire once energized. I’m using these to build a coyote deterrent box since they don’t like flashing lights. Good value!