Deals ⭐ NewYall Pack Of 2 80mm Headlight Dust Cover Cap Rubber Seal With 20mm Hole ✔️

8 reviews for Deals ⭐ NewYall Pack Of 2 80mm Headlight Dust Cover Cap Rubber Seal With 20mm Hole ✔️

1. 

   Rated 5 out of 5

   A. Chang – November 16, 2020

   If you look at the photo for this product juxtaposed against the OEM 33126-S0A-003, you’ll see that this product has an extra rubber “lip’ around the outside. At first, I tried to install the product as is by making that extra lip fit around the outermost part of the housing, but then I realized that the ring for the housing on a 2006 Honda CR-V doesn’t go all the way around; instead of being a complete circle, it’s more of a half or 3/4 circle.Following a hunch and kind of looking at the design, I took a pair of cheap kitchen scissors and essentially just cut the extra lip of this product off, and slowly stretched the small remaining flange over the inner housing of the bulb compartment, like the OEM product. Took a a few moments of patience of getting one side on, and then the other, and then two more corners, etc. until the entire dust cover was correctly seated and tight, but it got done.Just gently press the connector relay onto the pins when you’re done – the rubber squishes inwards and doesn’t adversely impact anything.Solid 3 stars – for about 30 seconds of work I saved $5 on each dust cover, and in the end things lined up and fit in a way that was at least usable.

2. 

   Rated 4 out of 5

   Donald A. Baxter – March 13, 2022

   I was repairing a botched LED headlight conversion on a 2008 Mazda 3. The previous owner had bought the wrong headlamps and because they didn’t fit in the housing, he had duct taped them in. Needless to say that didn’t work so the headlights just dangled outside the assembly lighting the inside of the engine compartment and not much of the road. I had one of the covers and one was missing so I had a vague idea of what to look for on Amazon. These are perfect fits including the cut out for where the electrical connection passes through. There is a round plug in adapter for the bulb (or LED assembly) that this set of caps fits and seals tightly. Very pleased with this replacement.

3. 

   Rated 4 out of 5

   Juan C. – July 11, 2022

   Fits my 2013 toyota tacoma crew cab sr5

4. 

   Rated 5 out of 5

   TX1 – July 19, 2022

   Perfect and high quality for 2010 FJ

5. 

   Rated 5 out of 5

   antricia – September 23, 2022

   Perfect

6. 

   Rated 4 out of 5

   Melchor – October 5, 2022

   The media could not be loaded.  Fits like a glove! Check out the video for comparisons with OEM.

7. 

   Rated 4 out of 5

   Motoguy – November 1, 2022

   Worked great to replace the pet on my 2017 CRF250L.

8. 

   Rated 5 out of 5

   Dorota – November 18, 2022

   It has no value for me, because it doesn’t fit. It’s too large ????