- Brand: DT MOTO
- Color: Red/White
- Specific Uses For Product: Strobe Lights
- Light Source Type: LED
- Vehicle Service Type: Emergency Vehicles, Safety Vehicles, Tow Trucks, Trucks, Utility Vehicles
- Special Feature: 3 Flash Patterns
- Voltage: 12 Volts
- Wattage: 2.4 watts
- Position: Unknown
- Lens Color: Red
- Set includes one set suitable for windshield/headliner placement and one set suitable for grille placement(See product images).
- Rainproof exterior ready.
- Three selectable flash patterns.
- Budget friendly strobe light set suitable for all automobiles with a 12VDC battery.
- 1 Year Warranty









































Spelunk68 –
Pros:Super bright, I was amazed at how bright these are for the price, you are definitely get your moneys worth for brightness.Great visibility day and night, possibly even too bright at night if aimed properly, I would go with a little down tilt to them if you are mounting them up high, they would get annoying to the person in front of you if responding in a convoy for long distances as we usually do (Not necessarily a con as how can you complain about brightness).Brainless two wire hook upNeutrals:Not as large as I thought, even though the size is listed I was still surprised at the smallness of them, but they are still a perfect size for my grill.Control box seems very cheap (but what do you expect for a package that is the same price as a single hide away strobe with no controls!)Cons:Wire length, if you are mounting these on your dash or overhead console wire length should be good (except the +/- to the controller those will probably need to be extended), however you are not going to make it to the grill with these . I will be upgrading the wiring to the control unit and mounting it in a waterproof project box in my engine compartment to get these to my grill. I am concerned about the current drop off if I extend all of the leads to my grill, so this way I just have to upgrade one set of wires. All of my strobes are powered through my siren/aux unit so I am not worried about having access to the controller for the pattern once it is set, I forgot to check if it retains the last setting for pattern but if it does not I will just rewire the control.Wire gauge: Very small wire, I would not extend these further than the included leads without upgrading the wire gauge.Orientation: as is my experience with ALL LED strobes and bars I have worked with down-tilt and up-tilt will take them from very bright to barely visible, so I would plan on using these basically as a 2 position strobe stacking them 3 high in 2 positions, then adjust the tilt from a far distance ahead of the vehicle to aim your max expected viewing distance down to close in so each takes over that distance and target height for brightness. You will not have bright lights unless you are looking directly in at these so take that into consideration when mounting. Again this is my experience with all LED’s that they are super sensitive to up and down tilts. This is why I always use a mix of strobes and LED’s.The main point to remember when purchasing these is that the cons are relative to the price, if you want a non tilt dependent, heavy gauge wire, long wire lengths, etc. etc. then spend hundreds on a controller and lights, and for 54 LED’s at that. These are a lot of light for the money.My primary use of these is a cheap way to add filler lights for added visibility on my truck.
Amazon Customer –
The media could not be loaded. Beware you will need to modify everything to get this to work for your application.
Elwin Reinhard –
This product did not come with suction cups, it did not even come with the mounting bolts for it. You have to buy it separately, and the install is very difficult and a lot of trim has to be removed
Matthew –
The media could not be loaded. I’ll start with, when I received the package one of the lights didn’t work. After contacting the company they immediately sent me a replacement light.The box is a little fragile feeling, but we have the same setup on our fourwheeler and it’s held up pretty good.The lights are pretty bright, I have very dark tint on my windows and they can still be seen a good distance away.Overall I’m very pleased, they fit my need really well.
Bryan –
Easy to install. The power button on the control doesn’t stay on so had to make some adjustments. The flashback is pretty over powering at night. You will need your own wire, an inline fuse and electrical connectors. This is not a plug and play setup. Electrical knowledge is needed for self install.
filips –
Perfect!
PASCUAL v. –
They are not as bright as I gathered they would from the description. They are hard to see during the day. They work great at night. The unit does not operate all the time. Every once in a while when you turn it on, nothing happens.
Colby –
Lights are decent wiring is messed up. Don’t provide enough extensions to power all the lights